Excursion 2WD V10-6.8L VIN Z CNG (2003)
![background image](/ford/excursion_2wd/v10-6.8l_vin_z_cng/Page-1711013.png)
6. Using the special tool, press the opposite bearing cup to just below the snap ring groove.
7. Install the new snap ring.
8. NOTE: Align the index marks made during disassembly.
Position the driveshaft center yoke on the spider.
9. Using the special tool, press the bearing cups into position.
^
Install the snap rings.
10. Apply grease.
11. On the one-piece rear driveshaft, install a new spring.