Excursion 2WD V8-5.4L SOHC VIN L (2000)
1. Remove the driver air bag from the vehicle.
2. Cut and strip the wires near the air bag connector.
3. Obtain two wires (20 gauge minimum) at least 6.1 meters (20 feet) long and attach one end of each wire to the stripped ends of the air bag wires.
4. Place the air bag module on a flat surface in an open outdoor area with the trim cover facing upward.
5. Remain at least 6.1 meters (20 feet) away from the air bag module.
6. Deploy the air bag module by touching the other ends of the two wires to the terminals of a 12-volt battery.
7. To allow for cooling, wait at least ten minutes before approaching the deployed air bag.
8. Dispose of the deployed air bag module in the same manner as any other part to be scrapped.
Passenger
WARNING:
^
ALWAYS WEAR SAFETY GLASSES WHEN REPAIRING AN AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS) VEHICLE
AND WHEN HANDLING AN AIR BAG MODULE OR SAFETY BELT RETRACTOR/PRETENSIONER ASSEMBLY. THIS WILL
REDUCE THE RISK OF INJURY IN THE EVENT OF AN ACCIDENTAL DEPLOYMENT.
^
CARRY A LIVE AIR BAG MODULE WITH THE AIR BAG AND TRIM COVER OR DEPLOYMENT DOOR POINTED AWAY
FROM YOUR BODY. THIS WILL REDUCE THE RISK OF INJURY IN THE EVENT OF AN ACCIDENTAL DEPLOYMENT.
^
REMOTE DEPLOYMENT IS TO BE PERFORMED OUTDOORS WITH ALL PERSONNEL AT LEAST 6.1 METERS (20 FEET)
AWAY TO ENSURE PERSONAL SAFETY. DUE TO THE LOUD REPORT WHICH OCCURS WHEN THE AIR BAG IS
DEPLOYED, HEARING PROTECTION IS REQUIRED.
^
DO NOT PLACE THE DRIVER OR PASSENGER AIR BAG MODULE WITH THE TRIM COVER OR DEPLOYMENT DOOR
FACING DOWN, AS THE FORCES OF THE DEPLOYING AIR BAG CAN CAUSE IT TO RICOCHET AND CAUSE PERSONAL
INJURY.
1. Remove the passenger air bag from the vehicle.