Excursion 2WD V8-5.4L SOHC VIN L (2000)
Air Bag Deactivation Switch: Service and Repair
REMOVAL
WARNING: TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BACKUP POWER SUPPLY MUST
BE DEPLETED BEFORE REPAIRING OR REPLACING ANY AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
COMPONENTS. TO DEPLETE THE BACKUP POWER SUPPLY ENERGY, DISCONNECT THE BATTERY GROUND CABLE AND
WAIT ONE MINUTE. BE SURE TO DISCONNECT AUXILIARY BATTERIES AND POWER SUPPLIES (IF SO EQUIPPED).
NOTE: A repair is made by replacement only. If a part is replaced and the new part does not correct the condition, install the original part and perform
the diagnostic procedure again.
1. Disconnect the battery ground cable.
2. Remove the instrument panel finish panel.
3. Remove the Passenger Air Bag Deactivation (PAD) switch.
1
Remove the retaining screws.
2
Remove the PAD switch.
INSTALLATION
NOTE: A repair is made by replacement only. If a part is replaced and the new part does not correct the condition, install the original part and perform
the diagnostic procedure again.
1. Follow the removal procedure in reverse order.