Excursion 2WD V8-5.4L SOHC VIN L (2000)
Ring Gear: Service and Repair
Rear Drive Axle/Differential-Dana 80
Special Tools
Disassembly
All differentials
1. Note:
^
Differential bearing shims are available in thicknesses of 0.762, 0.787, 0.813, 0.838, 0.864, 0.889 and 0.914 mm (0.030, 0.031, 0.032, 0.033,
0.034, 0.035 and 0.036 inch).
^
If damaged, install new differential bearing shims.
^
Install new differential bearings if removing them from the differential case.
Using the special tool, remove the differential bearings.
^
Wire the differential bearing shims, differential bearing cup, differential bearing, and selective outboard spacer(s) together. Note from which
side they were removed (differential ring gear side or the opposite side).
2. Note: Use a vise with brass jaws or wood blocks.
Place the differential case in a vise.
3. CAUTION: Do not damage the anti-lock speed sensor ring when removing the differential ring gear. If removing the anti-lock speed sensor ring,
discard it and install a new one.
Note: Always install new bolts upon assembly. Use Grade 9 bolts for all Dana rear axles.
Remove the bolts. Leave four bolts loosely assembled, 90 degrees apart.
