Excursion 4WD V10-6.8L (2002)
Rear Door Window Regulator: Service and Repair
REMOVAL
1. Remove the window control switch (if so equipped).
2. Remove the window crank handle (manual windows only).
1
Position the window crank handle cover aside.
2
Remove the window crank handle retaining screw and the window crank handle.
3. Remove the door trim panel and watershield.
4. Remove the window glass from the window regulator.
NOTE: Do not remove the window glass from the door.
5. Tape the window glass in the full up position.
6. Disconnect the window motor electrical connector (power windows only).