Excursion 4WD V10-6.8L (2002)
Seat Cushion: Service and Repair
Disassembly and Assembly
Bench
DISASSEMBLY
1. Remove the seat back.
2. Remove the four nuts and remove the two front seat floor supports.
3. Remove the four bolts and remove the front seat tracks.
4. Unfasten the eight seat cushion cover J-clips and remove the seat cushion cover.
5. Remove the seat cushion foam pad from the seat frame.
ASSEMBLY
1. To assemble, reverse the disassembly procedure.
NOTE: Make sure tracks inboard and outboard are synchronize. Check track engagement and rear track spring.
20 Percent
DISASSEMBLY
WARNING:
^
ALWAYS WEAR SAFETY GLASSES WHEN REPAIRING AN AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS) VEHICLE
AND WHEN HANDLING AN AIRBAG MODULE. THIS WILL REDUCE THE RISK OF INJURY IN THE EVENT OF AN
ACCIDENTAL DEPLOYMENT.
^
AFTER DEPLOYMENT, THE AIR BAG SURFACE CAN CONTAIN DEPOSITS OF SODIUM HYDROXIDE, A PRODUCT OF THE
GAS GENERANT COMBUSTION THAT IS IRRITATING TO THE SKIN. WASH YOUR HANDS WITH SOAP AND WATER