Excursion 4WD V10-6.8L (2002)
^
Stage 2: Tighten to 20 Nm (15 ft. lbs.).
^
Stage 3: Tighten an additional 90 degrees.
5. Attach the transmission cooling tube bracket and install the nut.
6. Lower the transmission.
7. Install the transmission mount nuts.
8. Remove the High Lift Transmission Jack.
9. If the vehicle is equipped with output shaft sensors (OSS), remove the plugs and install the sensors in the transmission.
10. Install the flywheel inspection plate.
11. Install the dual converter Y-pipe.
12. Position the engine oil cooler adapter and install the bolt.
13. Install the oil bypass filter.
14. Lower the vehicle.
15. Using a floor crane, remove the special tool.
16. Align the engine mount studs and lower the engine.