Excursion 4WD V10-6.8L (2002)
Wheel Hub (Locking): Service and Repair
Hublock
Hublock
Removal and Installation
1. Remove the hublock.
1
Remove the retainer ring.
2
CAUTION: To prevent damaging the hublock, do not use tools other than hands or "grip" gloves to remove the hublock.
Pull outward and remove the hublock.
2. To install, reverse the removal procedure.
-
Clean the O-ring seal contact area as necessary to provide a good O-ring seal. Install a new hublock O-ring seal kit. Apply a coat of Ford High
Temperature 4X4 Front Axle and Wheel Bearing Grease E8TZ-19590-A meeting Ford specification ESA-M1Ct98 to the O-ring seal and
contact area.
-
Push the hublock in firmly by hand to seat the O-ring seal completely.
-
Be sure the retainer ring is completely expanded into the wheel hub groove.
