Excursion 4WD V10-6.8L (2002)
NOTE: New safety belt buckles, height adjusters, center adjust tongues and belts and retractors can be installed separately. However, if a safety belt
assembly was in use during a collision, a new belt and retractor must be installed as well as the center adjust tongue and belt and buckle assembly, or the
center adjust tongue and the cable and buckle assembly. When installing new safety belts and buckles, height adjusters, safety cables and buckles, center
adjust tongues and belt and retractors, use only the parts specified in the Ford Master Parts Catalogs for the make and model of the vehicle being
repaired. Safety belt assemblies must not be interchanged between vehicle models.
1. Carefully pull out where indicated on the shoulder safety belt guide cover and open.
NOTE: Inspect the shoulder safety belt guide and cover for damage. If the shoulder safety belt guide or cover is damaged or cover does not
remain closed, install a new shoulder safety belt guide.
2. Remove the shoulder safety belt guide.
1
Remove the nut.
2
Remove the shoulder safety belt guide.
3. Pull out to release the retaining clips and remove the upper C-pillar trim panel.