Excursion 4WD V10-6.8L (2002)
8. Position the safety belt anchor and install the bolt.
NOTE: Prior to installation, make sure that the safety belt webbing is not twisted.
9. Remove the restraint system diagnostic tool from the safety belt retractor pretensioner floor electrical connector.
10. Connect the safety belt retractor pretensioner electrical connector.
11. Position the safety belt retractor pretensioner and install the bolt.
NOTE:
^
Make sure that after an automatic locking retraction (ALR) retractor is installed, the retractor is not in the ALR mode of operation when
installed.
^
Prior to installation, make sure that the safety belt webbing is not twisted.