Excursion 4WD V10-6.8L (2002)
6. CAUTION: Under no circumstances are power tools to-be used when performing these operations.
NOTE: The hub nut will ratchet as torque is applied.
Tighten the hub nut, rotating the rear hub occasionally while tightening.
7. Adjust hub nuts as follows:
-
For new bearings, ratchet back five teeth or notches (1/8 turn) on the hub nut. Five notches must be felt during this operation in order to have
performed it correctly.
-
For used bearings, ratchet back seven teeth or notches (1/6 turn) on the hub nut. Seven notches must be felt during this operation to have
performed it correctly.
8. Inspect the axle shaft O-ring seal for cracks, nicks or wear and replace it if required.
9. NOTE: Lubricate the O-ring seal with lubricant prior to installation of axle shaft.
Install the axle shaft.
