Excursion 4WD V10-6.8L (2002)
2. Index-mark the driveshaft at the axle flange.
3. Disconnect the driveshaft from the axle flange.
1
Remove and discard the bolts.
2
Remove and discard the U-joint retainers. Using mechanics wire, support the driveshaft.
4. Disconnect the driveshaft from the coupling shaft.
1
Remove and discard the bolts.
2
Remove the U-joint retainers.
-
Using mechanics wire, support the driveshaft.
5. Remove the center bearing support bolts.
6. Remove the rear driveshaft assembly.
