Excursion 4WD V10-6.8L VIN S (2000)
LABOR ALLOWANCES
PARTS REQUIREMENTS / ORDERING INFORMATION
Parts will not be direct shipped for this program. Order your parts requirements through normal order processing channels.
The DOR/COR for this program is 50364. This number identifies parts ordered for this recall through the Parts Support Center.
RECALL PARTS SUPPORT CENTER
The Recall Parts Support Center can be contacted via:
^
Phone
^
^
FAX
Please be prepared to provide the following information:
^
Dealer Name and P & A code
^
Contact Name
^
Phone number and E-mail address
^
FSA # : 06N05
^
Vehicle Identification Number
DEALER PRICE
For latest prices refer to DOES II.
PARTS RETENTION AND RETURN
Follow the provisions of the Warranty and Policy Manual for "Parts Retention and Return Procedures."
Attachment III - Technical Information
OVERVIEW
This program involves replacing the headlamp switch knob if it is either loose or missing from the affected vehicles. If the knob is not loose or missing,
replacement is not necessary and should not be performed.
SERVICE PROCEDURE
1.
NOTE: There are two (2) styles of headlamp switches depending on if the vehicle is equipped with or without fog lamps. Both switch styles use
the same knob.
For non-fog lamp equipped vehicles position the headlamp switch in the ON position. For fog lamp equipped vehicles position the headlamp
switch in the headlamp ON position and pull the knob out into the fog lamp ON position.
2.
CAUTION: To avoid possible damage to the headlamp switch bezel, use a piece of cardboard, or similar material, placed between the bezel and
the tool.