Excursion 4WD V10-6.8L VIN S (2000)
Tighten the pinion nut.
^
Install the Flange Holder to hold the flange while tightening the pinion nut.
^
Take frequent pinion bearing torque preload readings.
^
The final reading must be 0.56 Nm (5 inch lbs.) more than the initial reading taken during removal.
4. Align the index marks, and connect the driveshaft.
5. Check and, if necessary, fill the axle with the specified lubricant.
Ford 10.50-Inch Ring Gear
Special Tools
Removal
1. Remove the pinion flange.
2. Force up on the metal flange of the rear axle drive pinion seal. Install gripping pliers to the seal flange and strike with a hammer until the rear axle
drive pinion seal is removed.
Installation