Excursion 4WD V10-6.8L VIN S (2000)
Disconnect the driveshaft at the rear axle, and position it aside.
3. Note: Index mark the flange (end yoke for MOTORHOME) to the pinion shaft.
While using a suitable tool to prevent the flange or yoke from turning, remove the pinion nut.
4. Using the 2-Jaw Puller, remove the flange or yoke.
5. Using the Universal Bushing Remover and the Impact Slide Hammer, remove the pinion seal.
6. Clean the rear axle pinion seal seat.
Installation