Excursion 4WD V10-6.8L VIN S (2000)
Shifter Transfer Case: Service and Repair
Original Assembly
Removal
CAUTION: Carry out this procedure only if reinstalling the original transfer case control lever assembly. If installing a new transfer case control
lever assembly, refer to Transfer Case Shift Lever-New Assembly.
1. Shift the transfer case into 4H.
2. Remove the screws that attach the bezel and boot assembly to the floor.
3. Remove the bolt that attaches the shift lever to the transfer case control lever assembly, and remove the shift lever, and the bezel and boot
assembly.
1. Slide the bezel and boot assembly upward on the shift lever.
2. Remove the bolt, the shift lever, and the bezel and boot assembly.
4. Raise and support the vehicle.
5. Disconnect the control rod from the lower shifter arm.