EXP L4-098 1.6L VIN 4 2-bbl (1982)
Hall Effect Sensor: Technical Service Bulletins
Distributor Stator - Removal
Article No. 83-18-12
DISTRIBUTOR - 1.6L - STATOR REMOVAL
FORD 1981 TO PRESENT - ESCORT, EXP
LINCOLN-MERCURY 1981 TO PRESENT - LYNX, LN7
This article describes holding fixture for removal of distributor drive coupling pin, When removing the stator assembly using the procedures found in
Section 23-05 of the Shop Manual, use a 5/32" diameter punch to drive out the coupling pins. Do not use 1/8" punch as previously specified.
FIGURE 21
The fixture shown in Figure 21 should be used to assist the removal of bound or stuck pins. The fixture may be made from 1/4" stock.
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: "INFORMATION ONLY"