EXP L4-098 1.6L VIN 4 2-bbl (1982)
Internal Shift Linkage
1. Remove shift lever shaft from bore, then the back-up lamp switch. Use caution when removing shift lever shaft as the reverse inhibitor plunger is
spring loaded and may fly from its bore when shaft is removed.
2. Using screwdriver, remove reverse relay lever retaining C-clip, then the reverse relay lever. It is not necessary to remove pivot pin.
3. Remove control selector plate from case.
4. Position shift shaft into center detent position, then drive spring pin through selector plate arm assembly and through input shift shaft into recess in
clutch housing case.