EXP L4-098 1.6L VIN 4 2-bbl (1982)
FIGURE 4
3.
Using a piece of butyl adhesive sealer (D9AZ- 19562-A or B), roll it into a bead 1/8" to 3/16" diameter and 4-5" long and place it in the area of
the leak (Figure 4).
4.
With a plastic glass trim stick or bondo squeege, push the butyl adhesive sealer into the gap between the glass and the flange (usually around a
spacer or sheet metal joint). Figure 4, View A.
5.
Apply a light coat of liquid butyl after seal (C9AZ- 19554-B) to soften the adhesive and cause it to swell or flow into any gaps.
6.
After determining the seal is acceptable, reinstall the moldings.
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: "INFORMATION ONLY"