Expedition 2WD V8-281 4.6L SOHC (1998)
Control Module HVAC: Service and Repair
Illumination Bulbs
REMOVAL
1. Remove the control assembly.
2. Unsnap the bezel and pivot it open.
-
To replace the general illumination bulbs, unscrew the lamp holders and remove the bulb.
-
To replace the HI/LO bulb, cut the wires close to the bulb base, splice the wires to the new bulb and wrap the splice with electrical tape.
NOTE: Place the module upside-down on a non-marring surface.
INSTALLATION
1. Follow the removal procedure in reverse order.