Expedition 2WD V8-281 4.6L SOHC (1998)
1. Remove the driver seat safety belt buckle.
1. Disconnect the safety belt warning indicator switch electrical connector.
2. Use Safety Belt Bolt Bit to remove the bolt.
3. Remove the buckle.
NOTE: To ease removal, position the driver seat in its most rearward position and the passenger seat in its most forward position.
INSTALLATION
1. To install, reverse the removal procedure.
^
Check the restraint system for proper operation.
Front
Safety Belt Bolt Bit
Special Tool(s)
REMOVAL
NOTE: This procedure is for the LH side; RH side is similar.