Expedition 2WD V8-281 4.6L SOHC (1998)
Transmission Mount: Service and Repair
REMOVAL
1. If equipped, turn air suspension switch OFF.
2. Disconnect the battery ground cable.
3. Raise the vehicle on a hoist.
4. NOTE: To maintain initial driveshaft balance, mark the rear driveshaft yoke and axle flange so they may be installed in their original positions.
Remove the rear driveshaft.
1
Remove the four bolts.
2
Remove the driveshaft.
5. Use High-Lift Jack to support the transmission.
6. Remove the nuts.
7. Remove the bolts.