Expedition 2WD V8-281 4.6L SOHC (1998)
Valve Body: Service and Repair
Removal and Installation
REMOVAL
1. If equipped, turn the air suspension switch OFF.
2. Disconnect battery ground cable.
3. Raise and support the vehicle.
4. Drain transmission fluid and remove the transmission fluid pan and filter.
5. CAUTION: Do not pull on the plastic lead frame. This may cause damage to the connector ends. Carefully pry up on the locking tabs to
disconnect the sensors. Disconnect the molded lead frame from the sensors.
Disconnect the molded lead frame from the sensors.
1
Disconnect the shift solenoid SSA/SS1 and SSB/SS2.
2
Disconnect the Torque Converter Clutch (TCC).
3
Disconnect the electronic pressure control (EPC) solenoid.
4
Disconnect the bulkhead inter connector.
6. Remove the shift solenoid and the Torque Converter Clutch (TCC) solenoid.
1
Remove the bolts.