Expedition 2WD V8-281 4.6L SOHC (1998)
2. Drive the inner pinion bearing cup into the axle housing using the Pinion Bearing Cup Replacer and Driver Handle.
3. CAUTION: Whenever the cups are replaced, the pinion bearings must also be replaced.
Make sure the cups are properly seated in their bores.
-
If a feeler gauge can be inserted between a cup and the bottom of its bore at any point around the cup, the cup is not properly seated.
4. NOTE: Apply only a light oil film on the pinion bearings before assembling the tool. Assemble and position the Pinion Depth Gauge Set.
1
Position the Screw.
2
Position the Aligning Adapter.
3
Position the Gauge Disc.
4
Position the Gauge Block.
5
Position the inner pinion bearing.
6
Position the outer pinion bearing.
7
Thread on the Driver Handle.
