Expedition 2WD V8-281 4.6L SOHC (1998)
4. Install a new centering cup spring.
5. Install new bearing cups into the driveshaft yokes.
1
Start a new bearing cup into the driveshaft yoke.
2
Position the new spider in the driveshaft yoke.
3
Position the driveshaft in the U-Joint Tool.
4
Press the bearing cup below the yoke surface.
6. Install four new snap rings.
7. NOTE: Do not strike the bearings.
Check the U-joints for freedom of movement.
-
If bearings are binding, strike the yoke with a elastic hammer.
8. Install the driveshaft.