ford Workshop Repair Guides

Ford Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 1
background image

Pressure Regulating Solenoid: Service and Repair

REMOVAL 

1. Remove the manual control lever shaft.

2. Disconnect the electronic pressure control (EPC) solenoid electrical connector.

CAUTION:  Do not pull on the wires. This can damage the wires or the connector and can result in transmission solenoid or sensor failure.

3. Remove the EPC solenoid.

INSTALLATION 

1. Install the EPC solenoid.

2. Connect the electronic pressure control (EPC) solenoid electrical connector.

Transmission and Drivetrain > Actuators and Solenoids - Transmission and Drivetrain > Actuators and Solenoids - A/T > Pressure Regulating Solenoid, A/T > Component Information > Service and Repair

< PREV PAGE NEXT PAGE >