Expedition 2WD V8-281 4.6L VIN W EFI (1997)
NOTE
^
Apply with deliberate strokes, making sure not to overlap applied area.
^
Wipe off the Urethane Glass Prep immediately after application because it flash dries.
7. Cut the urethane applicator tip to specification.
8. Apply a urethane bead to the pinch weld just outside the foam butyl dam.
9. Install the inside rear view mirror.
10. Position the windshield glass.
11. Install the upper windshield weatherstrip.
12. Paddle the excess urethane from the two sides of the windshield glass.
NOTE: Use one continuous stroke when removing the excess urethane.
13. If necessary, remove excess urethane from the outside surface of the windshield glass.
