Expedition 2WD V8-4.6L SOHC VIN 6 (1999)
Rear Door Exterior Handle: Service and Repair
REMOVAL
1. Remove the rear door trim panel.
2. Remove the rear door watershield.
3. Remove the outside rear door handle.
1. Remove the nuts.
2. Disconnect the rear door latch to outside rear door handle rod.
3. Remove the outside rear door handle by pushing it out from the bottom surface of the handle.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: Make sure the door handle and the rear door handle rod is in a relaxed position and that the rear door handle rod is all the way up before
closing the clips.