Expedition 2WD V8-4.6L SOHC VIN 6 (1999)
Parking Brake Cable: Service and Repair
Rear Cable and Conduit
LH Rear Cable and Conduit
Removal
1. NOTE: Make sure the parking brake control is fully released.
Relieve the tension on the parking brake system.
1. Pull the front parking brake cable and conduit.
2. Insert a suitable retainer.
2. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the RH kick panel area. Failure to do so can result in
unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.
Raise and support the vehicle.
3. Separate the RH parking brake rear cable and conduit from the LH parking brake rear cable and conduit at the parking brake cable equalizer.
