Expedition 2WD V8-4.6L SOHC VIN 6 (1999)
4.
Inspect for the dimples and impressions. (Figures 1 and 2).
5.
If no permanent damage to the block and cylinder head decks is found, replace the cylinder head gasket using current service replacement parts.
6.
It damage is found, refer to the CYLINDER HEAD DECKS or CYLINDER BLOCK DECKS Instructions that follow.
CYLINDER HEAD DECKS
If such damage is spotted, check for flatness with a straight edge over the dimple or impression. If the dimple or impression on the head measures over
.025 mm (.001 ") deep, the cylinder head, gasket and bolts should be replaced with new. Refer to the parts listing table that follows.
CYLINDER BLOCK DECKS
Check for flatness with a straight edge over the dimple or impression. If the dimple or impression measures over .025 mm (.001") deep, the engine
should be replaced.
Parts Block
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES: 40100, 499000