Expedition 2WD V8-4.6L SOHC VIN 6 (1999)
4. To decrease caster and camber, use the following steps.
1
To decrease caster, move the front of the front suspension upper arm inboard and move the rear of the front suspension upper arm outboard.
2
To decrease camber, move the front suspension upper arm inboard equally.
5. NOTE: Each increment of the notches on the frame pocket represents 0.4°.
Set the caster and camber to specifications.
-
If a caster increase of 1.2° is required, move the front of the front suspension upper arm outboard by 3 notches and move the rear of the front
suspension upper arm inboard by 3 notches, since one notch represents 0.4°.
6. Tighten the upper suspension arm nuts.