Expedition 2WD V8-4.6L SOHC VIN 6 (1999)
4. Install a new centering cup spring.
5. Install new bearing cups into the driveshaft yokes.
1
Start a new bearing cup into the driveshaft yoke.
2
Position the new spider in the driveshaft yoke.
3
Position the driveshaft in the U-Joint Tool.
4
Press the bearing cup below the yoke surface.
6. Install four new snap rings.
7. NOTE: Do strike the bearings.
Check the U joints for freedom of movement.
^
If bearings are binding, strike the yoke with a plastic hammer.
8. Install the driveshaft.
Single Cardan