Expedition 2WD V8-4.6L SOHC VIN 6 (1999)
Axle Shaft: Service and Repair
8.8 Inch Ring Gear
Removal
1. WARNING: The electrical power to the air suspension system must be shut off prior hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the RH kick panel area. Failure to do so can result in
unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.
Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. Remove the differential housing cover.
^
Drain the lubricant.
4. Remove the brake discs.
5. Remove the differential pinion shaft.
1
Remove and discard the differential pinion shaft lock bolt.
2
Remove the differential pinion shaft.
6. CAUTION: Do not damage the rubber O-rings in the U-washer grooves.
Remove the U-washers.
1
Push the axle shafts inboard.
2
Remove the U-washers.
7. CAUTION: Do not damage the inner wheel bearing oil seal.
Remove the two axle shafts.
Installation
