ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Body and Frame|Cowl > < Procedures
Page 1
background image

Rear Bumper Cover / Fascia: Removal and Replacement

Bumper Cover - Rear

Removal and Installation

1. Remove the 4 LH and RH rear fender splash shield screws.

NOTE: Left side shown, right side similar.

2. Remove the 4 LH and RH inner bumper cover nuts.

3. If equipped, disconnect the reverse parking aid electrical connector.

4. Remove the 2 rear bumper cover lower pin-type retainers.

5. Remove the rear bumper cover.

-

Remove the 2 rear bumper cover pin-type retainers and the 3 rear bumper cover bolts.

6. To install, reverse the removal procedure.

Body and Frame|Cowl > < Procedures