Expedition 2WD V8-5.4L (2009)
Front Door Window Motor: Service and Repair
Window Regulator Motor - Front Door
Window Regulator Motor - Front Door
Removal and Installation
NOTE: The power window regulator motor must be re-initialized whenever the LF/RF (Navigator) or LF (Expedition) motor is removed from the
vehicle. For additional information, refer to Window Motor Initialization See: Windows and Glass/Windows/Service and Repair.
1. Remove the front door trim panel.
2. Position the front door weathershield aside.
3. NOTE: Use a flat-blade screwdriver between the window regulator motor and window regulator assembly to hold the window regulator assembly
drum in place.
Remove the bolts and the front door window regulator motor.
1. Disconnect the electrical connector.
2. Remove the bolts.
-
To install, tighten to 7 Nm (62 lb-in).
4. To install, reverse the removal procedure.
-
Cycle the window glass to make sure the gears engage.
-
The power window regulator motor must be re-initialized whenever the LF/RF (Navigator) or LF (Expedition) window regulator is removed
from the vehicle. For additional information, refer to Window Motor Initialization See: Windows and Glass/Windows/Service and Repair.