Expedition 2WD V8-5.4L (2009)
Rear Door Exterior Handle: Service and Repair
Exterior Rear Door Handle
Removal and Installation
NOTE: The door glass must be completely raised.
1. Remove the rear door trim panel.
-
Position the water shield aside.
2. Remove and discard the 3 bolts and position the rear door latch aside.
-
To install, tighten to 9 Nm (80 lb-in).
3. Open the clip and disconnect the exterior door handle actuating rod.
4. Remove the 2 nuts and the exterior rear door handle.
-
To install, tighten to 9 Nm (80 lb-in).
5. NOTE: Make sure the exterior door handle and the door handle actuating rod are in a relaxed position and that the exterior door handle rod is all
the way up before closing the clip.
To install, reverse the removal procedure.
