Expedition 2WD V8-5.4L (2009)
Hood Latch: Service and Repair
Hood Latch
NOTE: Expedition shown, Navigator similar.
Removal and Installation
1. Remove the 10 pin-type retainers and the upper radiator sight shield.
2. Remove the 2 bolts and the hood latch.
-
To install, tighten to 35 Nm (26 lb-ft).
3. Release the hood latch cable from the hood latch.
4. To install, reverse the removal procedure.
-
Verify the hood latch engages the striker in the latched position (secondary).
-
Verify the hood latch engages the striker in the fully latched position (primary).
-
Adjust the hood latch as necessary.
