Expedition 2WD V8-5.4L (2009)
Trunk / Liftgate Shock / Support: Service and Repair
Power Liftgate Rod
Removal and Installation
1. Remove the LH quarter trim panel.
2. Unclip the power liftgate rod from the motor assembly.
-
Squeeze the clip as shown to release and position upward on the rod assembly.
3. Remove the cover and the power liftgate rod-to-liftgate retaining nut.
-
To install, apply threadlock to the threads of fastener and tighten to 11 Nm (97 lb-in).
