Expedition 2WD V8-5.4L (2009)
5. Disconnect the ambient air temperature sensor retaining clip and position the sensor and harness aside.
6. Disconnect the horn assembly electrical connector and remove the horn assemble bracket bolt.
-
To install, tighten to 35 Nm (26 lb-ft).
7. Disconnect the hood latch cable retainers, remove the hood latch assembly bolts and position the latch assembly and cable aside.
-
To install, tighten to 35 Nm (26 lb-ft).
8. Remove the LH and RH coolant module bolts.
-
To install, tighten to 15 Nm (133 lb-in).
9. Remove the 6 radiator grille support bolts (3 each side).
-
To install, tighten to 35 Nm (26 lb-ft).
