Expedition 2WD V8-5.4L (2009)
Keyless Entry Transmitter: Testing and Inspection
Autolock and Auto-Unlock Programming
Autolock and Auto-Unlock Programming
Programming the Autolock Feature Using the Door Lock Control Switch
NOTE: This feature can also be enabled or disabled using the message center switch functions, if equipped.
NOTE: The autolock feature can be enabled or disabled independently of the auto-unlock feature.
NOTE: The following steps must be carried out within 30 seconds or the procedure will need to be repeated. If the procedure needs to be repeated, wait
30 seconds between programming sessions.
1. Turn the ignition switch from the OFF to the RUN position.
2. Press the unlock button on the door lock control 3 times.
3. Turn the ignition switch from the RUN to the OFF position.
4. Press the unlock button on the door lock control switch 3 times.
5. Turn the ignition switch to the RUN position. The horn chirps one time to indicate that programming mode is entered.
6. NOTE: The unlock and lock buttons must be pressed within 5 seconds of each other.
Within 30 seconds of entering the programming mode, press the unlock button and then the lock button on the door lock control switch within 5
seconds to enable/disable the autolock feature. The horn chirps once if the autolocks are disabled or a chirp followed by a honk if the autolocks are
enabled.
7. Programming ends when the ignition switch state changes or times out after 2 minutes.
Programming the Auto-Unlock Feature Using the Door Lock Control Switch
NOTE: This feature can also be enabled or disabled using the message center switch functions, if equipped.
NOTE: The auto-unlock feature can be enabled or disabled independently of the autolock feature.
NOTE: The following steps must be carried out within 30 seconds or the procedure will need to be repeated. If the procedure needs to be repeated, wait
30 seconds between programming sessions.
1. Turn the ignition switch from the OFF to the RUN position.
2. Press the unlock button on the door unlock control 3 times.
3. Turn the ignition switch from the RUN to the OFF position.
4. Press the unlock button on the door lock control switch 3 times.
5. Turn the ignition switch to the RUN position. The horn chirps one time to indicate that programming mode is entered.
6. NOTE: The lock and unlock buttons must be pressed within 5 seconds of each other.
Within 30 seconds of entering the programming mode, press the lock button on the door lock control switch then the unlock button to
enable/disable the auto-unlock feature. The horn chirps once if the autolocks are disabled or a chirp followed by a honk if the autolocks are
enabled.
7. Programming ends when the ignition switch state changes or times out after 2 minutes.
Programming the Autolock Feature Using the Keyless Entry Keypad
NOTE: The autolock feature can be enabled or disabled independently of the auto-unlock feature.
NOTE: The following steps must be carried out within 30 seconds or the procedure needs to be repeated. If the procedure needs to be repeated, wait 30
seconds between programming sessions.
