Expedition 2WD V8-5.4L (2009)
Power Seat Motor: Service and Repair
Power-Fold Seat Motor
Power-Fold Seat Motor
Removal and Installation
NOTE: For parts identification and locations, refer to Seat - Exploded View, Third Row See: Service and Repair/Third Row Seats/Seat - Exploded
View, Third Row.
1. Remove the load floor panel.
2. Remove the 2 bolts and mid-floor panel support.
-
Release the 3 pin-type retainers.
3. Disconnect the power seat motor electrical connector and detach the wiring harness.
4. Remove the bracket-to-pivot bolt and bushing from the power-fold seat motor.
-
Note bushing shoulder position for correct installation.
-
To install, tighten to 30 Nm (22 lb-ft).
5. Remove the bracket-to-latch bolt and power-fold seat motor.
-
Slide the power-fold seat motor and bracket away from the latch and torque shaft.
-
For installation, slightly rotate the torque shaft until seated into the power-fold seat motor.
-
To install, tighten to 30 Nm (22 lb-ft).
6. To install, reverse the removal procedure.
