Expedition 2WD V8-5.4L (2009)
-
Note cable routing for correct installation.
11. Remove the 2 side air bag module nuts.
-
To install, tighten to 10 Nm (89 lb-in).
12. Position the backrest foam aside and remove the side air bag module from the backrest frame. Then slide the side air bag module out of the seat
backrest cover deployment chute.
-
For installation, position the locator pin and mounting studs through the holes in the deployment chute and backrest frame.
13. Disconnect the electrical connector and remove the side air bag module.
14. Detach the 3 pin-type retainers and side air bag wiring harness.
15. For power and climate controlled seat, disconnect the backrest wiring harness electrical connector and route the wire harness from the cushion.
16. Release the cushion cover fastener from the rear inboard side.
17. Remove the 4 backrest frame-to-seat track bolts and backrest.
-
To install, tighten to 45 Nm (33 lb-ft).
18. WARNING: Check the seat side air bag deployment chute for damage. The deployment chute must not be repaired. If there is any
damage to the deployment chute, a new seat back trim cover and deployment chute must be installed as a unit. Failure to follow these
instructions may result in the seat side air bag module deploying incorrectly and increase the risk of serious personal injury or death in a
crash.
WARNING: Before installing the seat side air bag module/deployment chute assembly:
-
Inspect the side air bag module and mounting surfaces for any damage or foreign material.
-
Remove any foreign material from the mounting surfaces of the deployment chute, the seat backrest frame mounting bracket and the
air bag module cavity in the seat backrest foam pad.
-
Install new parts if damaged.
