Expedition 2WD V8-5.4L (2009)
1. For additional information, refer to the procedures.
Seat Backrest Cover - Second Row, 20 Percent
Seat Backrest Cover - Second Row, 20 Percent
Removal and Installation
NOTE: For parts identification and locations, refer to Seat - Exploded View, Second Row See: Service and Repair/Second Row Seats/Seat - Exploded
View, Second Row.
1. Remove the screw and pivot bolt cover.
-
Route the attaching strap through the pivot bolt cover.
2. Release the 2 lower backrest cover J-clips.
3. Remove the pin-type retainer and detach the LH side attaching strap.
4. Remove the 2 screws and RH side shield.
-
Raise the backrest upright to access and remove the center screw.
-
Release the 2 pin-type retainers.
5. Remove the pin-type retainer and detach the RH attaching strap.
-
Note attaching strap routing for correct installation.
6. Remove the safety belt anchor bolt.
-
To install, tighten to 55 Nm (41 lb-ft).
