Expedition 2WD V8-5.4L (2009)
Seat Heater Switch: Service and Repair
Seat Control Switch - Front
Seat Control Switch - Front
Removal and Installation
WARNING: Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to
follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which
increases the risk of serious personal injury or death.
WARNING: Never probe the electrical connectors on air bag, Safety Canopy(R) or side air curtain modules. Failure to follow this instruction
may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
NOTE: For component identification and locations, refer to Seat - Exploded View, Front See: Service and Repair/Front Seats/Seat - Exploded View,
Front.
NOTE: Driver seat shown, passenger similar.
All seats
1. NOTICE: Do not pull from the inboard side of the front seat cushion panel shield to avoid damaging it.
Remove the front seat cushion panel shield.
-
Release the upper retaining clips working from the outboard side and then release the lower retaining clips.
Side shield with insert
2. Release the retainers and remove the insert from the side shield.
-
Disconnect the electrical connector(s).
Side shield with cover
3. Remove the front side shield screw.
4. Remove the side shield cover.
-
Disconnect the electrical connector(s).
