Expedition 2WD V8-5.4L (2009)
1. For additional information, refer to the procedures.
Brake Caliper Anchor Plate
Brake Caliper Anchor Plate
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
Failure to follow these instructions may result in serious personal injury.
NOTICE: Do not spill brake fluid onto painted or plastic surfaces or damage to surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
1. Check the brake fluid level in the brake master cylinder reservoir.
-
If required, remove the fluid until the brake master cylinder reservoir is half full.
2. Remove the wheel and tire.
3. NOTICE: Do not allow the caliper and brake pad assembly to hang from the brake hose or damage to the hose may occur.
Remove the 2 brake caliper guide pin caps and bolts and position the caliper and brake pad assembly aside.
-
Support the caliper using mechanic's wire.
-
Inspect the guide pin threads for damage and inspect the guide pin bushings for wear/damage. Install a new guide pin(s) and bushing(s) as
necessary.
-
To install, tighten to 38 Nm (28 lb-ft).
4. Remove the 2 brake caliper anchor plate bolts and the brake caliper anchor plate.
-
Inspect the caliper anchor plate bolt threads for damage and foreign material. Install cleaned and dried anchor plate bolts or install new as
necessary.
-
To install, tighten to 190 Nm (140 lb-ft).
5. Clean, dry and inspect the brake caliper anchor plate. Apply equal amounts of the supplied yellow lubricant to the 4 brake pad contact points on
the anchor plate as indicated.
