Expedition 2WD V8-5.4L (2009)
NOTE: On vehicles equipped with RSC(R), the ABS module is available separately from the HCU and should be serviced separately. However, if the
RSC(R)-equipped vehicle requires a new HCU, then the ABS module and the HCU must be installed as an assembly. Make sure to use the most recently
released service parts.
NOTE: When installing a new ABS module/HCU assembly, it must be configured (either by download/upload or uploading the as-built data method).
1. Disconnect the ABS module electrical connector.
2. NOTICE: Only authorized inlet hydraulic brake tubes should be used. These tubes are of specific design and only authorized parts
should be used when installing new inlet brake tubes. Use of other than authorized inlet brake tubes may result in damage to the
components.
NOTE: Plug each open port to prevent brake fluid from spilling.
Disconnect the 6 brake tube fittings.
-
To install:
-
Tighten the master cylinder brake tube fittings to 25 Nm (18 lb-ft).
-
Tighten the remaining brake tube fittings to 20 Nm (177 lb-in).
3. Remove the 3 HCU-to-bracket bolts and the HCU.
-
To install, tighten to 9 Nm (80 lb-in).
4. To install, reverse the removal procedure.
-
Bleed the brake system.
5. If installing a new ABS module/HCU assembly on a vehicle equipped with RSC(R), configure the ABS module.
