Expedition 2WD V8-5.4L (2009)
7. Disconnect the ABS wheel speed sensor wire from the retaining clip.
8. Release the parking brake cable from the LH bracket assembly.
9. Release the cable from the parking brake actuating lever and remove the cable.
10. To install, reverse the removal procedure.
Parking Brake Cable - Rear, RH
Parking Brake Cable - Rear, RH
Removal and Installation
1. Relieve the tension on the parking brake cable system. For additional information, refer to Parking Brake Cable Tension Release See: Procedures.
2. With the vehicle in NEUTRAL, position it on a hoist.
3. Disconnect the RH rear cable from the cable union.
4. Compress the 2 tabs and release the conduit from the equalizer.
