Expedition 2WD V8-5.4L (2009)
10. Disconnect the RH Variable Camshaft Timing (VCT) solenoid electrical connector.
11. Disconnect the 2 engine wiring harness retainers from the RH valve cover studs and position the wiring harness aside.
12. NOTICE: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools
cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
NOTICE: When removing the valve cover, make sure to avoid damaging the Variable Camshaft Timing (VCT) solenoid.
NOTE: The fasteners are part of the valve cover and should not be removed.
Loosen the 9 fasteners and remove the RH valve cover and gasket.
-
Clean the valve cover mating surface of the cylinder head with silicone gasket remover and metal surface prep. Follow the directions on the
packaging.
-
Discard the valve cover gasket. Clean the valve cover gasket groove with soap and water or a suitable solvent.
Installation
All vehicles
1. NOTE: If the valve cover is not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with silicone gasket remover
and metal surface prep. Follow the directions on the packaging. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer.
Failure to follow this procedure can cause future oil leakage.
Apply a bead of silicone gasket and sealant in 2 places where the engine front cover meets the cylinder head.
2. NOTICE: When installing the valve cover, make sure to avoid damaging the Variable Camshaft Timing (VCT) solenoid.
Position the RH valve cover and new gasket on the cylinder head and tighten the 9 fasteners in the sequence shown.
-
Tighten to 10 Nm (89 lb-in).
3. Install the 4 RH ignition coils.
4. Position back the engine wiring harness and connect the 2 electrical connectors and the wiring harness retainer.
