Expedition 2WD V8-5.4L (2009)
Drive Belt Tensioner: Service and Repair
Accessory Drive Belt Tensioner
Accessory Drive Belt Tensioner
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the pushpin, press the position retaining tab and rotate the lower cooling fan shroud upward until the position retainer tab locks into
position.
3. Rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the A/C compressor pulley.
4. Remove the 3 bolts and the accessory drive belt tensioner.
-
To install, tighten to 25 Nm (18 lb-ft).
5. To install, reverse the removal procedure.