Expedition 2WD V8-5.4L (2009)
3. Position a new gasket and the oil pan and install the 16 bolts.
-
Tighten the bolts in the sequence shown in 3 stages.
-
Stage 1: Tighten to 2 Nm (18 lb-in).
-
Stage 2: Tighten to 20 Nm (177 lb-in).
-
Stage 3: Tighten an additional 60 degrees.
4. Attach the oil pressure switch wiring harness to the oil pan bolt.
5. Position the transmission fluid cooler tube support bracket, the starter wiring harness support bracket and install the nut.
-
Tighten to 10 Nm (89 lb-in).
6. Press the position retaining tab and rotate the lower cooling fan shroud downward until the position retainer tab locks into position. Install the
pushpin.